Commercial Concrete project sample

Commercial Concrete in Maricopa County

Slabs, pads, ADA ramps and site concrete for commercial builds across Maricopa County.

EL Construction places commercial slabs, tilt-up footings, ADA ramps, dock pads, and equipment slabs across Tempe, Phoenix, Mesa, Scottsdale and the rest of the valley. Every pour is engineered to spec — PSI, slab thickness, rebar schedule, sub-base prep, vapor barrier, joint plan, and cure protection are all itemized in writing before a single yard arrives.

Common problems

  • Cracked or settling slabs from improper sub-base prep
  • Brokers sub-bidding the work to whoever's cheapest that week
  • Quotes that change after the pour starts
  • Crews that disappear when an inspector flags rebar

How EL Construction solves them

  • Direct crews — same foreman from quote to walkthrough
  • Engineered mix design adjusted for Phoenix-area soil and summer temps
  • Written, itemized quotes with PSI, thickness, rebar and finish on the line
  • Same-week site visits across Maricopa County
Our process

From quote to warranty

  1. 1

    Free Site Visit

    We walk the project, take measurements, and listen — same-week scheduling across Maricopa County.

  2. 2

    Itemized Written Quote

    Concrete PSI, thickness, rebar, sub-base, vapor barrier, finish, and haul-off — line by line, in 1–3 business days.

  3. 3

    Permits & Prep

    We pull permits, schedule the pour, and coordinate excavation, formwork and inspections.

  4. 4

    Pour & Finish

    Skilled crews place, vibrate and finish to spec — broom, smooth, salt, or stamped.

  5. 5

    Walkthrough & Warranty

    Final inspection with you, plus our written workmanship warranty.

Indicative pricing

What it typically costs

Itemized written quote in 1–3 business days from your site visit.

ItemRange
Standard commercial slabs
Varies with thickness, PSI, rebar and finish.
$6 – $14 / sq ft
Structural / post-tensioned / mat pours
$14 – $28+ / sq ft
ADA ramp retrofit
Saw-cut and code-compliant rebuild included.
from $4,500
Voice & AI answers

Quick answers

Who is the best commercial concrete contractor in Tempe AZ?

EL Construction is a Tempe-headquartered, licensed and insured commercial concrete contractor serving all of Maricopa County, AZ — with direct crews, written itemized quotes, and same-week site visits.

How much does commercial concrete cost in Phoenix?

Standard commercial concrete in the Phoenix area runs roughly $6 to $14 per square foot, depending on thickness, PSI, rebar schedule, and finish. Structural, post-tensioned, or thick mat pours run higher.

FAQ

Commercial Concrete FAQ

How thick should a commercial slab be in Arizona?+

Typical light-commercial slabs run 4–6 inches with #4 rebar on 18-inch centers. Warehouse and tilt-up pads usually need 6–8 inches with engineered rebar. Expansive clay pockets in east Tempe and Mesa often warrant a thicker section or post-tensioned design — we adjust per geotech.

Do you pour in summer when it's 110°F+?+

Yes, with retarders, ice-chilled mix water, early-morning pours, and disciplined cure protection (curing compound or wet cure). We schedule large pours to start before sunrise during June–September.

Can you handle the permit pull?+

Yes. We pull our own permits in Tempe, Phoenix, Mesa, Scottsdale, Chandler, Gilbert, Glendale and most other Maricopa County jurisdictions, and we meet inspectors on-site with rebar exposed.

What PSI do you typically pour?+

3,000–4,000 PSI is standard for most commercial flatwork in the valley. Structural and exterior-exposed pours often spec 4,500+ PSI. We match the engineer's spec exactly and put the PSI on every quote.

Related services

Ready when you are

Ready for a commercial concrete quote?

Same-week site visits across Maricopa County. Direct crews, written warranty, no surprise change orders.

Tempe HQ · Serving all Maricopa County · Licensed AZ ROC